Do you know how to paint? If you think the question is quite simple to answer, and most of you would have nodded affirmatively, think of the last time when you painted something – your kitchen cabinet, perhaps.
Were you satisfied with what you painted? Are you sure about that wall you painted had only one shade? Did you get shocked when you calculated the cost on paint products? Didn’t you feel you could have hired a professional painter for that much expense? And most importantly, how long did that paint last on your wall, cabinet or ceiling?
Some of you would have left the job in the middle and hired a painter to complete it. Painting is a tricky job. It requires special skills to mix colors and chemicals in the right proportion.
You need to make a solution that could hold the wall instead of dropping on the floor. That’s where professional painters are good. Not only they apply the paint in the right manner, they also save you two or three extra buckets of paint.
Cabinet painting in Toronto is quite common, and there are few good companies. Among the best ones, Renaissance Toronto cabinet painting service undoubtedly lies at the top. The company doesn’t only provide kitchen cabinet refinishing in Toronto, but also deals with other painting services.
According to the cabinet painting service mentioned above, following are the four painting secrets professionals wouldn’t teach you,
When Loading the Paintbrush
How much paint can your brush take in one dip? It’s not about calculation, its about saving the paint. You probably want to dip the whole brush in to the paint to get as much paint as possible. It will not only waste the paint, but your brush will get thicker and harder quickly. Professional painters in Toronto would dip the paintbrush about 1.5”. While taking it out, they don’t wipe each side because it will loose the paint, they tap it slightly to knock off the drips while securing the paint into bristles.
Cutting in Close
Professional painters have special skills to cut in. That’s something one cannot achieve with ratty brush. Load the brush and spread out excess paint. A wider brush stroke creates hatband. You can avoid this first apply the roller then cut in with the brush. In this way you will know where to apply the brush and save time.
How to Work With the Brush
Once you finished ceiling, work from top down. Begin with crown molding, then finish the walls, then paint the areas around doors and windows. The last thing to do is baseboard molding
Recheck Your Work
After you’ve finished the first coat, completely analyze your work. Sand off bumps and check for drips and roller flecks. Make sure you sand them off before applying the second coat.
These tips and tricks will not only make your task easier, you’ll end up saving your time and paint.