What would you do if your furnace system stops working when you need it the most? Your panic button immediately activates and you rush hunting down the experts’ contacts.
But wait! What if this article gives you few troubleshooting tips to handle during those dreaded moments? Well, this article by the experts of furnace repair Tomball, TX, presents few valuable tips as to how to take care of the furnace system, during its problematic period.
The following are just a few simple tips to take care of the problem temporarily. Do not depend on it completely and call the experienced professionals of Wrightway Comfort once the matter is under control for further repairing and diagnosis.
Getting back to the troubleshooting tips, if you are facing this cold situation in the dead of the night, before calling the experts, try out the following measures. But if nothing works out, call the experts of heating services Tomball, TX, as early as possible.
Table of Contents
Common Troubleshooting Tips
Is the Thermostat set to Heat Mode?
This may sound silly and obvious, but trust the experts, this is one of the most common reasons for furnace issues. Many people either accidentally or without much information set the thermostat wrong. Double-check the thermostat for its right setting. Most of the time, even the mischievous kids in the house set it wrong causing havoc in our comfort zone. Check whether it is set to Heat mode and that the temperature is set at a point that will turn the furnace on.
Give it some time for the system to operate and kick on. If the result is the same, then try setting it to 90 degrees Fahrenheit.
If nothing seems to work, move on to the next step.
Is the Furnace Filter Clean?
The common reason for furnace failure is dirty or clogged air filters. If the cleaning period has extended three months’ time, then this can be a problem. The air filter must be cleaned once in 2-3 months for better and efficient operation. A clogged and dirty air filter restricts the smooth airflow and builds up pressure in the system. This will then create more problems in the system resulting in parts failures and damages.
Check the air filter for dirt and clogs. Clean or replace it if dirty and try listening for a whistling sound. If you hear a whistling sound, then it indicates a problem, which eventually requires help from the professionals of furnace repair Tomball, TX.
Inspect whether the Furnace is Getting Enough Power
If the furnace does not receive enough power, then it will fail in its basic operation. One way to know whether the system receives enough power is by switching the Fan Mode On. If the fan runs without any trouble, then the system is getting enough power. If not, then know that there is some trouble with the interior parts.
Check The Battery
Most of the furnace system is connected to the electrical system of the house. But few are wired to the batteries. If your furnace system runs through the battery, then check for the low-power symbol and act it accordingly.
Check the Circuit Breaker
If all the above has given you no fruit, then try inspecting the circuit breaker that plays the lead in controlling the furnace system. See whether it has tripped or has been switched off.
Check the Gas Valve
Check the gas valve of the furnace system and see whether it has been switched off. The gas furnace comes with a gas cock that must be located in a reach of six feet of the furnace system. This place is mostly untouched and unvisited. See whether it is working fine and that the gas line is in good condition. If you find issues with the gas line, then do not attempt to do anything and call the experts for further help.
Do not conclude that these tips will solve your problem completely as they will only act for a temporary period. Only an expert will know the root cause of the problem. Therefore, once you are done with the tips, contact the experts as soon as possible for further diagnosis and repairs.